Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You might discover that your garage door opener has been providing you troubles, so you need to repair it. You can repair it by changing a circuit card, a photo-eye sensor, the major drive gear, or the set-limit switches. You can likewise check if the safety sensing units are working effectively.

Replacing a circuit board

Replacing a motherboard for your garage door opener requires a few steps and also tools. Initially, you require to turn off the breaker and also detach any wires. Next, open up the motherboard cover. This will help you to detect the problem as well as figure out if you need a new board. Next off, remove the old board and its cord adapters.

You can after that proceed to replace the circuit card. The substitute process is easy and takes about 10 mins. A brand-new circuit card will certainly cost about $80. To protect your new circuit card from power surges, you can purchase a rise guard.

Replacing a photo-eye sensing unit

Replacing a photo-eye sensor can be a fairly easy job. Initially, eliminate the sensing unit from the door and also make certain it is located appropriately. If the sensing unit is angled whatsoever, it may not be receiving the right signal, which can be creating the blinking lights. If you see that the photo-eyes are out of alignment, you may need to have a professional come and also fix the trouble.

The photo-eye sensing unit consists of 2 items that place on the outside of the door tracks and also toward the floor. The image eyes will have a little LED light and also need to be solid in shade. If the light is blinking, its likely the photo-eye is malfunctioning and will require to be changed.

Replacing a major drive equipment

To change a garage door opener major drive equipment, begin by getting rid of the cap from the chain wheel. Next, eliminate the two screws holding the drive equipment to the gear setting up. Currently, you can unfasten the 3 tension pins. Squeeze them from both sides and after that remove them. After that, separate the 3 wires from the garage door opener electric motor. These wires should be white, red, as well as blue.

When you have eliminated the old gear, set up a brand-new one. Make certain to grease it well. Insert the brand-new gear right into the shaft, making certain to line up the mounting openings. Ensure the equipment as well as sprocket setting up are positioned properly to make certain smooth operation. Next, make use of a hammer as well as a nail to drive a pin right into the brand-new gear.

Adjusting the set-limit switches

The initial thing you must do if your garage door is not functioning appropriately is to inspect the set-limit switches. You might need to change them to ensure that the door shuts earlier or stops prior to it reaches the floor. You can inspect this by checking out your garage doors guidebook or online.

To readjust the set-limit buttons, youll require a screwdriver or socket. Readjust the knob clockwise or counterclockwise up until the door moves up as well as quits, or lowers its distance. To look for proper travel range, determine the space from all-time low of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *