Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You might locate that your garage door opener has been giving you troubles, so you require to repair it. You can repair it by changing a circuit board, a photo-eye sensing unit, the primary drive equipment, or the set-limit switches. You can additionally examine if the security sensing units are working appropriately.

Changing a circuit card

Changing a circuit board for your garage door opener requires a couple of steps and also tools. Initially, you require to shut off the breaker and separate any type of cords. Next off, open up the circuit card cover. This will certainly help you to identify the issue as well as identify if you need a new board. Next, eliminate the old board and its cord ports.

You can then continue to change the circuit card. The replacement process is easy as well as takes about 10 mins. A brand-new circuit board will cost regarding $80. To protect your brand-new circuit card from power surges, you can purchase a surge guard.

Replacing a photo-eye sensor

Replacing a photo-eye sensor can be a fairly easy task. First, eliminate the sensor from the door and ensure it is located appropriately. If the sensor is angled in any way, it may not be getting the appropriate signal, which might be causing the blinking lights. If you notice that the photo-eyes run out alignment, you might require to have actually a service technician come and deal with the trouble.

The photo-eye sensor contains two pieces that place on the outside of the door tracks and also towards the floor. The photo eyes will certainly have a tiny LED light and also ought to be strong in shade. If the light is blinking, its likely the photo-eye is malfunctioning and will need to be changed.

Replacing a major drive equipment

To change a garage door opener major drive gear, start by eliminating the cap from the chain pulley. Next off, eliminate the two screws holding the drive gear to the sprocket setting up. Now, you can unfasten the 3 stress pins. Squeeze them from both sides and afterwards remove them. After that, disconnect the 3 wires from the garage door opener electric motor. These cords ought to be white, red, as well as blue.

As soon as you have removed the old gear, set up a new one. Make certain to grease it well. Put the brand-new gear into the shaft, seeing to it to align the installing holes. Make certain the equipment and also gear setting up are located correctly to guarantee smooth operation. Next, use a hammer as well as a nail to drive a pin right into the new equipment.

Adjusting the set-limit switches

The very first point you should do if your garage door is not functioning properly is to check the set-limit switches. You may require to change them to make sure that the door shuts earlier or stops prior to it gets to the floor. You can check this by taking a look at your garage doors handbook or online.

To adjust the set-limit buttons, youll need a screwdriver or outlet. Readjust the knob clockwise or counterclockwise up until the door goes up and also quits, or reduces its range. To check for appropriate travel distance, measure the void from all-time low of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, USA

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488
Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

By Karl

Leave a Reply

Your email address will not be published. Required fields are marked *